In between the third and fourth photo, there was a fast flow of text that I wasn't able to photograph - so part of the text is missing - but the final photo shows where it lands at the end, before it fails. I'm attaching photos of the onscreen logs from the most recent attempt. I still get the pause followed by the "forbidden"/"prohibited" circle-with-diagonal-line and the Apple URL (which superimposes itself in a way that breaks up the existing onscreen type). I tried twice after that - before and after re-changing the "ReleaseUSBOwnership" quirk back to "true" (which was one of the fixes recommended above that I reversed, since my machine got messed up - the other was adding AHCIPortInjector.kext). Mere mortals just grab their camera.Ĭlick to expand.Despite not being able to run Macserial (see my thread here) I was able to populate the four relevant data in the "PlatformInfo" area of ist, by finding the corresponding entries in my working 2017 Clover/Sierra install (which runs on the same hardware as the new OpenCore/Big Sur boot drive I'm trying to make). You want "Purchase Date not validated" (could be a real serial number, but not in use… and in 2021 it is unlikely that any corresponding genuine MacPro will be switched on and report to Cupertino headquarters for the first time ever) or " Invalid Serial" (no real Mac has this, but the set of three numbers is still consistent and VirtualSMC can use it to boot OS X).Ĭorrect, OpenCore is working, there's nothing more to learn from its log.Īs to the debug messages from the kernel, well, if you have a serial port on the motherboard, a suitable cable and another computer, you could redirect them to the serial console and capture them from a terminal session on the receiving computer-like kernel programmers do. If a purchase date is returned, do NOT use this set: A real Mac has this serial number, and logging in to the AppleStore with it would land both you and the owner of the real Mac in trouble. Generate a few sets, and then go to Apple Check Coverage to check their status. Sandy and Ivy Bridge-E | OpenCore Install Guide ON EDIT: Here's my "PlatformInfo" (see attached screengrab excerpt from "ProperTree"): Obviously if any of you kind people end up recommending that I try them again, I'll listen. Both of those changes were "shots in the dark," which is how I hate proceeding with Hackintosh stuff (or any tech stuff). I changed the machine name to "MacPro6,1".is that the only change that needs to be made in that section of the config file? (It's part of a chunk of machine-identifying entries including a serial-number-looking string of digits.)īTW I'm rolling back to before I made those two final changes (based on the guide's advice about the "prohibited" screen) - the "ReleaseUsbOwnership" quirk and "AHCIPOrtInjector.kext" - because they not only didn't fix the problem, but they bricked my machine: I had to manually restore a portion of my Clover install (on the partition of my main boot drive) and reset the bios to find my Clover/Sierra drive.and when I came back up my two monitors had reversed and I had to switch their connectors. I understand that OpenCore "DEBUG" is now useless since arrival at the "picker" means that OpenCore is done and has handed off to Darwin/Apple bootloader - is there a way to capture those subsequent onscreen logs? (I assume "no" since you're recommending photos.) Building a CustoMac Hackintosh: Buyer's GuideĬlick to expand.I'll do that, thank you.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |